|
Server
|
This setting displays as read only because you
specified the server when you performed the find notification destination procedure.
To change the server where you want to provide
access, perform the procedure to find an SNMP user.
|
|
User Name
|
In the field, enter the name of the user for which
you want to provide access. The name can contain up to 32 characters and can
contain any combination of alphanumeric characters, hyphens (-), and underscore
characters (_).
| Tip
|
Enter users that you have already configured for the network
management system (NMS).
|
For existing SNMP users, this setting displays as
read only.
|
|
Authentication Required
|
To require authentication, check the check box, enter
the password in the Password and Reenter Password fields, and choose the
appropriate protocol. The password must contain at least 8 characters.
|
|
Privacy Required
|
If you checked the Authentication Required check box,
you can specify privacy information. To require privacy, check the check box,
enter the password in the Password and Reenter Password fields, and check the
protocol check box. The password must contain at least 8 characters.
| Tip
| After you check the Privacy Required check box,
the DES (Data Encryption Standard) check box automatically appears checked. The
DES protocol prevents packets from being disclosed.
|
|
|
Accept SNMP Packets from any host
|
To accept SNMP packets from any host, click the radio
button.
|
|
Accept SNMP Packets only from these hosts
|
To accept SNMP packets from specific hosts, click the
radio button. In the Host IP Address field, enter a host from which you want to
accept SNMP packets and click
Insert. Repeat this process for each
host from which you want to accept SNMP packets. To delete a host, choose that
host from the Host IP Addresses pane and click
Remove.
|
|
Access Privileges
|
From the drop-down list box, choose one of the
following options for the access level:
- ReadOnly
The user can only read the values of MIB objects.
- ReadWrite
The user can read and write the values of MIB objects.
- ReadWriteNotify
The user can
read and write the values of MIB objects and send MIB object values for a trap
and inform messages.
- NotifyOnly
The user can only send MIB object values for trap and inform messages.
- ReadNotifyOnly
The user can
read values of MIB objects and also send the values for trap and inform
messages.
- None
The
user cannot read, write, or send trap information.
| Tip
| To change the trap configuration parameters,
you need to configure a user with NotifyOnly, ReadNotifyOnly, or
ReadWriteNotify privileges.
|
|
|
Apply To All Nodes
|
To apply the user configuration to all nodes in the
cluster, check this check box.
This applies to Cisco Unified Communications Manager and IM and Presence Service clusters only.
|